WizardOfRealms

Sitting here and watching the paint dry. XRP Long

WizardOfRealms Updated   
db.tt/SQNAFROd92

I hope this further explains "what it is I am doing" to get these numbers... and gives "some who think they have seen this before" a better idea of what it is and is not.

The numbers have changed slightly (not by much) due to the low of .85121 and because I had to reset the lower and upper fib-lines to get the variances.
The way this program works is: It takes the HIGHEST HIGH and the LOWEST LOW to get the "SPREAD" which is currently: .37849 Cents.
The program then calculates: 25%, 50%, 75%, 88% and 100% (of the spread.) It then calculates New Highs and Lows (based on the spread.)

So, instead of say XRP is @ 1.20 and 100% of that would be 2.40...
The program calculates 100% of the spread (or) currently .37849 and adds that to: 1.20 for a max currently @ 100% to be: 1.57849!
Some say they have seen this story before, I beg to differ. This is a mathematical set of calculations based on my creation of deep thoughts.

I even created variances of the FIB LINES for further accuracy. Then, I further select the lowest advance which is currently: .09462 (or) 25% of the current spread.
I use this for the "Buy Backs" whether it is buy back after the sell of a "DIP BUYING RUN" (or) The Buy-back after the Sell on the CORE HOLDINGS.

A new feature added today was the "BUY BACK" after the sell on the DIP BUY-IN(s).
@ 20% stake in buying and selling (means, you'll get profit - instead of holding and hoping for it to hit your high - to find out it doesn't get there.)
This 25% of the spread is nice! Because instead of thinking in terms of HIGHT of the COIN, you can think if "INCREMENTS" of the spread for profits.
Example; Lets say the coin moves up 10 cents today and doesn't come down. Then, it moves up another 10 cents or 15 cents... (25 cents) and drops back only .09462...
You will have sold some and (bought an amount less than what you sold it at for a gain!) This is the general rule of thumb... not to sell and buy back higher... That's a NO NO.
Anyways, This helps make sure profit is being taken no matter what.

What I have noticed is that generally only 4 of my 5 transactions on the "DIP-BUY(INS) will occur" and the same goes with "CORE HOLDINGS!" Generally the first 4 triggers will sell and not the 5th one... THIS IS FINE! Generally, at that time I then put in the new HIGH and leave the current low as is since it has not made a new lower low... and continue to calculate NEW DIP-BUY(INS) and NEW CORE HOLDINGS.

If you have been following me on this program... know that 4 of the 5 DIP BUY-INS triggered and the lower one did not. And, none of the sell orders executed which means... you can now plug in these BUY-IN(S) on the DIP - sell and buy-back numbers. And, for CORE HOLDINGS, reenter the SELL ORDER and buy back numbers as it changed by roughly a penny or two.

Regards, The Wiz
And, may the fortunes be with you!

P.S. I dont' think anyone has seen a program quite like this...
click here to view: db.tt/PBZXEp9eOT
To view it better... after you click on the link... look at the bottom... select full view and then click on the plus sign and select 100%
Comment:
STOP LOSS is SET to: (.85) "which the previous hit was @ .85112" .
Trade active:
Trade is highly active! Good luck hodlers!
May good fortunes be with you.
Trade closed: stop reached:
stop loss of .85 triggered...
Comment:
Breakout is about to occur!!! Watch the chart!
1 hr. Chart db.tt/vkh0me3kRK

Disclaimer

The information and publications are not meant to be, and do not constitute, financial, investment, trading, or other types of advice or recommendations supplied or endorsed by TradingView. Read more in the Terms of Use.